Loading... Please wait...
- Home
- Plumbing: Pumps-Parts-Fittings
- Bilge Pump & Accessories
- Rule Rule-Mate 2000 GPH Fully Automated Bilge Pump 12V RM2000A Boat Sailboat
Categories
- HOME
- ATV - UTV Parts (4 Wheeler)
- BBQ-Cooler-Kitchen-Appliances
- Boat Accessories: Deck-Cabin
- Boat Inboard I/O Engine Parts
- Boat Outboard Engine Parts
- Boat Steering & Control
- Motorcycles Dirt/Super Bikes
- Electrical
- Engine Maintenance Parts
- Fishing
- Fuel: Tank-Filter-Sender-Parts
- General Boating
- GPS Fishfinder Navigation
- Hardware
- Jetboat & PWC Watercraft Parts
- Maintenance & Care
- Paint & Accessories & Tools
- Plumbing: Pumps-Parts-Fittings
- RV Camper Outdoor Hitch Tow
- Propellers-Skeg Guard-Anodes
- Sailing-Sailboat
- Snowmobile Parts
- Sports & Recreation & Clothing
- Stereo Receiver Speaker Amps
- Trailer Parts Trailering
- Trolling Motors & Accessories
- Used Parts
- Used & Remanufactured Engines
- Ventilation: Blower-Hatch-AC
- Others
)
Product Description
BRAND: Rule
DESCRIPTION:
Rule-Mate 2000 GPH 12 Volt Fully Automated Bilge Pump
The Rule-Mate 2000 GPH pump consists of a powerful Rule bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed the pump will revert to its normal operation turning on when the water reaches 2-1/2" and shutting off at 5/8".
Manufacturer Part Number: RM2000A
Internal Code: 53261
Need more info?
Ask a question.
We answer questions quickly....
DESCRIPTION:
Rule-Mate 2000 GPH 12 Volt Fully Automated Bilge Pump
The Rule-Mate 2000 GPH pump consists of a powerful Rule bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed the pump will revert to its normal operation turning on when the water reaches 2-1/2" and shutting off at 5/8".
- 2000 GPH (7570 LPH) at 0' (13.6V)
- All-in-one pump and switch
- Extra long life heavy duty motor
- 1" NPS discharge with 1" AND 1 1/8" screw-on ports
- Three year warranty
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
Manufacturer Part Number: RM2000A
Internal Code: 53261
Need more info?
Ask a question.
We answer questions quickly....
