Johnson Evinrude 60 Degree 135-150-175 HP Lower Unit RH 20 Shaft Gear 1991-05 EI

Ready to be install once you receive it... 

NEW aftermarket LOWER UNIT.  Design to fit MOST BUT MAYBE NOT ALL engine V6 from 150 -175 HP, years 1991 to 2005. 

DOUBTS?? SEND US YOUR ENGINE MODEL NUMBER......

3 year NO fault warranty in the USA........ 

Once you pay the order, we will install a NEW 20" or 25" driveshaft according to the length of your midsection.  Then, we install a NEW water pump kit, pressure test and ad NEW Sierra gearcase oil. Then, we ad 2 coats of paint, waiting 24 hours per coat for perfect drying and finally create a custom box.  SET UP PROCESS TAKES 3-4 DAYS.

You will need to use a 1991 or newer prop thrust washer.

Please see important measurement below for fitting.

General Information:

• 20" or 25" driveshaft for 20" or 25" mid sections.
• 15 spline propeller shaft for 15 spline propellers.
• Designed for V6 engines 4 3/4 diameter in the bullet or propeller with diameter above 14"
• You will need to use a 1991 or newer prop thrust washer. You can use your old one whne installing the propeller.

IMPORTANT DIMENSSIONS for you to compare to your lower unit:

• Drive shaft measurements: From top of lower unit housing (same as the bottom of water pump) to top of drive shaft 22 1/4 or 27 1/4" for looper 90 degree engines and (one inch less for 60 degree engines). if your measurements ends on 3/4 or 7/8 this lower unit do not fit, as yours will be the old style pre 1991-1992.  We have those as well.
•  Propeller shaft with 15 splines.  Propeller bullet 4 3/4 external diameter.
•  Shifter rod is not that big deal as you can use yours. 

Satisfaction guaranteed in all products we sell. Returns accepted in 14 days for money back IN NEW CONDITION UNUSED ITEMS.